• broken image

    How to use the tweezers to start the car battery?

    It can happen to all of us that, without waiting for it, we run out of the car battery, because it is already exhausted or due to carelessness; the result is the same: you run out of a car. If you are in a hurry, it is a serious problem, and even more so if it is an emergency. Visit this link to gain more ideas: Best Jumper Cables

     

    To fix it, if you have been foresighted and have a starter pliers, it only takes someone with another vehicle to help you make a battery jumper to start the engine .

     

    But it is an operation that may cause some fright , so you have to be careful; Also, keep in mind that starting a modern car is not the same as starting an old one. In new cars electronics is very important and can cause a bigger problem. And in all cases you have to take into account that the two batteries have to be of the same voltage.

     

    Safety recommendations:

     

    For safety and for you to start the car engine, there are a series of recommendations that you must follow:

    • The clamps must be of good quality, with thick cables, and must be in perfect condition. The normal (and necessary) thing is that they have two colors, red for the positive pole and black for the negative, so you don't make a serious mistake.
     
    • Cars should not touch each other. The only connection between the two vehicles will be made with the clamps.
     
    • With both hoods open, make sure which are the negative and positive terminals. Then, with the engines stopped, first place the clamp of the positive pole in the car battery discharged at one end, and then to the positive terminal of the car charged at the other. Then start by connecting the negative pole clamp to the negative terminal of the charged car first, and connect its other end to the negative terminal of the discharged car battery. In vehicles with an intelligent charge sensor, it is advisable not to place the negative clamp exactly on the same negative pole of the battery. You should look for a farther place that manufacturers normally already allow for it. Pay close attention not to leave the clamps on top of the batteries while doing this process because it can be very dangerous. The positive clamp should never be left in any part of the vehicle while handling it.
     
    • Once the calipers are placed in the right place, you have to start the car with the battery in good condition and then you have to start the one that has failed . Then you must proceed just the opposite of what you have done when placing them, starting with removing the negative from the assisted car.

    Booster starters and maintenance

     

    If you have a booster starter, everything will be easier, because they do not need an auxiliary car. They are safer systems, especially if your starter has polarity reversal protection. In this case, you will only have to connect the cables (if you do it wrongly it will not allow it), turn on the starter (which must be loaded) and that's it, you can start the engine.

     

    Regardless the easiest way to prevent surprises is to carry out regular maintenance, to have a mechanic check the condition and replace it when it shows signs of exhaustion, which generally occurs over 3-4 years. If you must change it, better that a specialist do it.